Changzhou Taisheng Machinery Equipment Co.,Ltd.
TS Machinery - Specialize In Fabricating Shot And Sand Blasting Equipment For Surface Treatment Industry More Than 10 Years.
Add to Cart
80 Gallon Vacuum Blasting Machine For Removing Rust Cleaning Paint Welding Scale
Description
Vacuum, or dust free blasting is ideal for spot repairs, and has high demand on the environment which should be dust free and abrasive pollution is prohibited.
The blasting process is happened in a sealed chamber by the brush head, curve or flat. Dust and abrasives are immediately vacuumed by a powerful suction fan. The used abrasives are recycled to the separator and silo, the dust is collector by the cartridge filter. TS machinery vacuum blasting is a safe blasting solution for confined or critical areas (with a lower working speed compared to “open” blasting).
Application
The equipment can be widely used in petrochemical industry, metal structure, ship repair, pipeline power, aerospace aviation, locomotive manufacturing and other industries. It is an ideal tool for pre-processing of various steel structures.
Benefits if using TS vacuum blasting,
1. 100% dust free operation because of fully automated vacuum start/stop sequence
2. Clean, abrasive free surface after blasting
3. Automatic filter cleaning system
4. Unit can be movable easily
5. Wide range of brushes to fit all (flat, cornered, radius) surfaces
6. Working radius is 10m(the maximum radius could be 40m). The cleanliness is up to Grade Sa2.5-Sa3
7. Handle controlled switch(Electric control DC24V)
8. Adopts special control circuit, and the working pressure can be adjusted arbitrarily in the range of 0.2kpa - 0.8kpa, which can meet the requirement of sand blasting process for different workpieces.
Technical Specification
| Model | TS-300L |
| Size | 2100x1100x2300(L*W*H) |
| Weight | About 600kg |
| Voltage | 380V 50HZ |
| The dia of nozzle | 8mm |
| Working pressure | 4-7bar |
| Working radius | 10m |
| Working efficiency | 10-15m²/h |
| Working type | Automatic recycle type |
| Air consumption | 3-6m³/min(recommend to match with 37kw air compressor) |
| Fan power | 2x4kw |
| Filtration area | About 20m² |
| Cleaning level | Sa2.5-3 |
| Roughness | 40-70μm |
| Usable abrasive | G25-150 grits |
Failure and Troubleshooting
| Failure | Probable Cause | Troubleshooting |
| Small compressed air | Small air pressure in the regulator valve. | Rotate regulator valve, adjust the air pressure. |
| Continuous air flow with no sand or discontinuous sand |
|
|
| Abrasive blasted is uneven |
|
|
| Low recycle system efficiency |
|
|
| Too much blasted sand |
|
|
| Low working efficiency |
|
|