Changzhou Taisheng Machinery Equipment Co.,Ltd.
TS Machinery - Specialize In Fabricating Shot And Sand Blasting Equipment For Surface Treatment Industry More Than 10 Years.
Add to Cart
Tumble Belt Shot Blast Machine Q326 With Rubber Belt Automatic Shot Blaster
Introduction
Tumble blast machine with rubber belt is ideal for mass-produced parts, which can be tumbled and will perfectly meet your requirements for batch cleaning, decoring, descaling, deflashing, deburring, and shot peening parts. They are mostly used for process ferrous and non-ferrous castings, forgings and heat treated parts.
Shot blasting machine is a cleaning effect , compact structure, low noise, complete and good cleaning equipment, has the following characteristics:
1. The machine uses cantilever certrifugal blast wheel,has a long life,simple structure and other characteristics.
2. By full curtain winning abrasive mixture separator,with good separation effects and higher productivity,has a positive effect to improve the life of the blasting blade.
3. Use wear-resistant rubber track,decreasing workpiece collision damage phenomenon and then reduce the noise of the machine.
4. Use pulse dust collector,dust can be collected in the dust hopper or exclude to outdoors,improve the labor environment.
Specification
| Model Spec. | Q326 |
| Productivity(T/h) | 0.6-1.2 |
| Maximum Load (kg) | 200 |
| Maximum Product (kg) | 10 |
| Disc Dia.(mm) | 600 |
| Capacity(m³) | 0.15 |
| Shot Flow(kg/min) | 100 |
| Separate Type | Sieve + Air Wash |
| Air Volume(m³/h) | 2200 |
| Power(kw) | 10.85 |
Parts Introduction
This is a small cleaning equipment, mainly composed by the cabinet, blasting system, abrasive recycle system, dust collector, electrical system and etc.
a. Blasting Cabinet(Longer Serive Time)
Inside the cabinet, there equips with wearing-resistant rubber to carry the products rotate. The shell is protected by special wear-resistant alloy shield mounted on end sides of belt, which is made by high chromium iron casting.
b. TS Blast Wheel (High Efficiency + Longer Service time)
It is key part of shot blasting machine, consists of blades, control cage, wheel disc, impeller, protective linings, wheel house, feeding pipe, special motor and etc.
c. Door (Good Sealing)
It is single swing door hanging with wear-resistant rubber to protect the door and sealing.
d. Elevator + Air Wash Separator
(with advanced design, dust and abrasive can be separated up to 99.5%)
To ensure conveyor belt not slip when machine is working, the pulley was made into a squirrel cage, that increase friction between belt and pulley, reduce the press-tightening force, extend belt service life. While elevator is equipped with a tension device, belt can be tensed by adjusting the upper bolt when it loose.
e. Cartridge Dust Collector(More Easier to Clean)
Pulse-jet Air Clean System
The dust collector has a push button to “pulse” the cartridges with a jet of compressed air between blast cycle to purge the filter. Upgrade option, the part can be programmed in PLC.
f. Electrical Control Panel (More Safty)
Qualified electronic components from famous company, such as Schneider, Chint or other Equivalent brand;
With Emergency Button; Control Voltage 24V;
Interlock System: there is a limit switch above the door, only after the door closed, can the blasting wheel be started.
Before and After
Why choose tumble belt shot blasting machine from TS Blasting?
Tumble belt shot blast machine is blast cleaning equipment for casting parts, forging parts and small fabricated metal work pieces. Tumble belt rotates with work pieces on it at the bottom of blasting chamber. Blasting wheels on top blast steel shots and grits on work pieces. Left and right chamber are protected by alloy liners.
Package